Mercury Monterey, 1959-1960
Convertible Top and Convertible Top Parts

Haartz Pinpoint Vinyl’s design is original to most American cars from the fifties to the nineties. Pinpoint refers to the little dots or pips that you see if you look closely at the vinyl surface. European cars, such as the old Beetles and others also used pinpoint vinyl as the topping fabric.

Haartz Stayfast Canvas has a canvas outer layer and a preshrunk cotton inner layer. The two are bonded with and separated by a butyl rubber core. It is this core that makes the fabric last a very long time, with both better static and dynamic wear ratings than vinyl toppings. Haartz Stayfast is the American substitute for the German canvases used in Mercedes, Porsche, BMW, some models of Mustang and Lebaron and others. Canvas is widely regarded as "richer looking" than vinyl. It is a little harder to clean. The inside of the top is pre-shrunk cotton. The inner lining is usually black. If you do not see a canvas top listed for your car, please inquire and we will provide a quotation for it.

Installation:
This is a classic two part top: the main top and the rear window sections are integrated during the installation process.

Installation involves stapling (using stainless steel staples) and gluing. There is no sewing. If you are confident using an air driven staple gun then you are a good candidate for do-it-yourself installation. You can read a summary of our 'two part top' manual via the blue link at the bottom of this page.

Rear Window:
As original, the rear window section has a zippered window. The plastic is the highest grade 'Regalite' DOT approved plastic for windows.

Tack Strips:
Tacking strips are embedded in the header and rear top frame bows. They receive the staples. We offer replacement strips. (If your lower--below the back window--tacking belts need replacement please inquire.)

Hold down cables:
Cables are threaded through the side hems of the top and hold the top to the framework. They are not visible after installation. New cables are recommended with each new top.

Pads:
Pads are installed under the top. They 'build out' the top along the sides.

Boots:
A boot is optional; it receives and covers the top in the down position. We strongly recommend choosing a boot in a modern boot vinyl. This has some "give" and is much easier to use than a boot made in a topping fabric. Boots are usually chosen to complement the paint or interior colors.

1961-62 boots originally installed with 39 snaps. We provide new snaps. Installation of the boot requires lining new snaps up with the body snap receptacle locations, punching snap hole and banging in the new snap. This is a straightforward job and the "anvil" tool kit is provided, with instructions.

Package Specials:
Our packages are designed to provide everything you will need for a full restoration job.

Hydraulics:

We now stock hydraulic cylinders, motor-pumps, and hoses for your convertible tops. All are made to OEM specifications. Each can be ordered separately; however, when ordering hydraulic cylinders we recommend replacing both. The chances are that both hydraulic cylinders were manufactured at the same time: if one is on its way out the other may follow. If the top is raised and one hydraulic cylinder is working harder than the other the result over time can lead to a slightly bent convertible top frame. The replacement of both hydraulic cylinders will ensure that the top raises and lowers symmetrically.

Systems for this car take Automatic Transmission Fluid (ATF) and have a 5 year warranty when used with this fluid. Brake fluid should not be used as it voids the warranty. We also offer an installation manual when ordered.

The 12 volt motor-pumps include a mounting bracket with rubber grommets to reduce vibration.

We also offer a rebuilding service for motor-pumps. Not all are repairable, but it is less expensive to have one rebuilt than to buy a new one. The motor-pump would need to be sent to us for evaluation. Hoses come with all new fittings and are made specifically to fit your car.

Parts in this category (Mercury Monterey) fit cars for years: 1959 and 1960.

We a now pleased to offer hydraulic cylinders, hydraulic motor pumps, and hydraulic hose sets for many different convertibles, they will be listed on your cars page if available. Also, checkout our newly added roof rail weatherstripping seals, front header weatherstripping seals, door weatherstripping seals, trunk weatherstripping seals. Look for extra savings on weatherstripping seals kits.

We are continuing to grow our convertible related products: These include convertible top latches, tonneau covers, relays, switches, rear tacking rails (trimsticks), seat covers, car covers, and carpeting.

Email questions to: support@mtmfg.com Shipping Warranty		Payment Processing
Copyright © 2012 M&T Manufacturing, 30 Hopkins Lane, South Kingstown, RI 02879