Home
About Us
Contact Us
Help
Site Map
View Cart1966 Plymouth Belvedere, GTX, Satellite (B Body) Convertible Top and Convertible Top Parts
All Take The Same Top
Cleaning & Protectant | Important Information
Original Patterns:
The convertibles listed above have identical top frames and take the same top. Our Plymouth Belvedere convertible tops are made from original dealer patterns.
Fabrics:
Original dealer tops were in pinpoint vinyl. We offer genuine Haartz pinpoint vinyl fabric replacement tops.
We also offer the same tops in Haartz Stayfast canvas. This is an elegant, maximally durable fabric. You can read more about fabrics via the "Help" link at the top of this page.
Windows:
The window is plastic as original. We use only the most stable and densest plastic windows available.
Installation:
This is a classic two part top. If you are comfortable with using an air driven staple gun and with aligning and gluing with contact cement then the installation should be within your capabilities. You can make an informed decision about self installation by reading the manual summary via the link at the bottom of this page.
Hold Down Cables:
A pair of cables, one on each side, thread through pocketed hems on the main top sides. The ends of the cables hold the top to the frame. New cables are recommended with each new top.
Tacking strips:
Much of the installation involves tacking or stapling (there is no sewing involved.) Tacking into the bow over the windshield (header bow) and into the bow over the rear window (rear top bow) is done into special strips embedded in these frame bows. We offer new tack strips for the front and rear top bows. They should not be required until after at least two tops have been stapled to them.
Top pads:
Top padding "builds out" the top. Pads can last through two tops but should be replaced if of suspect condition.
Top Boots:
You have the option of using a top storage boot. Our boot fits, as original. Replacement boots are listed under "Accessories."
Hydraulics:
We now stock hydraulic cylinders, motor-pumps, and hoses for your convertible tops. All are made to OEM specifications. Each can be ordered separately; however, when ordering hydraulic cylinders we recommend replacing both. The chances are that both hydraulic cylinders were manufactured at the same time: if one is on its way out the other may follow. If the top is raised and one hydraulic cylinder is working harder than the other the result over time can lead to a slightly bent convertible top frame. The replacement of both hydraulic cylinders will ensure that the top raises and lowers symmetrically.
Systems for this car take Automatic Transmission Fluid (ATF) and have a 5 year warranty when used with this fluid. Brake fluid should not be used as it voids the warranty. We also offer an installation manual when ordered.
The 12 volt motor-pumps include a mounting bracket with rubber grommets to reduce vibration.
We also offer a rebuilding service for motor-pumps. Not all are repairable, but it is less expensive to have one rebuilt than to buy a new one. The motor-pump would need to be sent to us for evaluation. Hoses come with all new fittings and are made specifically to fit your car.
We a now pleased to offer hydraulic cylinders, hydraulic motor pumps, and hydraulic hose sets. Also, checkout our newly added roof rail weatherstripping seals, front header weatherstripping seals, door weatherstripping seals, trunk weatherstripping seals. Look for extra savings on weatherstripping seals kits.
